Neuspeed 49.10.95 User Manual
Page 8
22. MAF AND AIR BOX COVER INSTALLATION: Remove
O-ring from factory air box cover, lubricate, and transfer to new
air box cover. Install MAF on new air box cover using factory
screws. Now install air box cover to lower half using factory
screws from stock cover. Snap on air pump hose, and re-install
throttle body to air filter air intake hose. NOTE: If you do not
have an air pump, you should have been provided a plain air box
cover without a hole or fitting.
21C. Remove air duct by removing M6 nut (10mm hex) and
sliding duct up and out towards windshield.
23. Install new supplied coolant hose mounting bracket. Transfer
factory hose clamp by snapping into hole and slot – clamp hose.
NOTE: Threaded insert is for the factory engine cover post.
21D. Disassemble air duct by removing two (2) Phillips screws.
21E. Locate mesh screen and cut around perimeter of air duct to
remove. (Mesh screen has already been removed from picture).
Page 8