Keri Systems EntraGuard Bronze Quick Start - Manual (Page 28)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-001 Rev. J
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 28 of 32
Quick S
tart Guide
Telephone Entry
7.0 Table of Programming Commands
Programming commands can be performed at the EntraGuard Bronze unit or the residence
telephone.
Programming Command Instructions
Enter Programming Mode
From the Bronze Unit
• Press .
• Press – the six-digit
programming code.
• The unit emits a short high-pitched tone to indicate the unit is
in programming mode. If no sound is emitted an invalid
programming code has been entered.
Enter Programming Mode
From the Residence
Telephone
• Press .
• Press – the six-digit
programming code.
• The unit emits a short high-pitched tone to indicate the unit is
in programming mode. If no sound is emitted an invalid
programming code has been entered.
All subsequent commands assume the EntraGuard Bronze unit is in Programming Mode.
Add an Entry Code
Default = 123
• Press .
• Press – the desired entry code.
• Press . The unit emits a short high-pitched tone to indicate
the code has been accepted. A high-low tone is emitted if an
invalid programming code has been entered.
Delete an Entry Code
• Press .
• Press – the entry code to be deleted.
• Press . The unit emits a short high-pitched tone to indicate
the code has been deleted. A high-low tone is emitted if an
invalid entry code has been entered.