Keri Systems EntraGuard Bronze Quick Start - Manual (Page 12)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-001 Rev. J
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 12 of 32
Quick S
tart Guide
Telephone Entry
3.6 Gate Operation From The Residence Telephone
Gate Operation from the Resident Telephone command allows you to immediately open a gate from
the residence telephone.
• To connect the residence telephone to the EntraGuard Bronze unit for gate operation, press
three times with a brief delay between key presses.
• To open Gate 1 from the EntraGuard Bronze unit, press , press , and press the user’s
three-digit entry code.
• To open Gate 2 from the EntraGuard Bronze unit, press , press , and press the user’s
three-digit entry code.
• If a code entry mistake is made, the user can cancel the entry by pressing the key at any
time.
EXAMPLE: Enter the following to open Gate 1 from the residence telephone with a user entry code
of “212.”
4.0 Resetting the EntraGuard Bronze’s Microprocessor
The EntraGuard Bronze comes with basic features pre-programmed. To reset the microprocessor
(and clear all pre-programming), perform the following steps.
1. Turn unit power OFF.
2. Press and hold the and keys.
3. Turn unit power ON.
4. Release the and keys.
The unit is now reset.
NOTE: Performing a reset completely erases ALL pre-programming and restores the EntraGuard
Bronze to the factory defaults.