Keri Systems EntraGuard Bronze Quick Start - Manual (Page 19)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-001 Rev. J
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 19 of 32
Telephone Entry
Quick S
tart Guide
EXAMPLE: Enter the following to set the maximum number of rings to “10.”
4. You can now enter another program command or press to exit programming mode.
5.3.8 Set Gate 1 Relay Access Code
The Gate 1 Relay Access Code is a single-digit number that, when entered at the residence
telephone, activates gate relay 1 allowing access. Perform the following to set the gate 1 relay
access code.
1. Press .
2. Enter the desired relay 1 activation code – (default code is “9”).
3. Press to lock in the new gate 1 relay access code. The unit emits a short, high-pitched tone
to indicate the gate 1 relay access code has been accepted. The unit emits a short, high-pitched
tone followed by a low-pitched tone if the gate 1 relay access code has been rejected.
EXAMPLE: Enter the following to set a Relay 1 Activation Code of “5.”
4. You can now enter another program command or press to exit programming mode.
5.3.9 Set Gate 1 Relay Timeout
The Gate 1 Relay Timeout sets the time, in seconds, that the gate 1 relay is activated. The timeout
value range is from 1 to 65 seconds; if you enter 0, the relay will never open. Perform the following
to set the gate 1 relay timeout value.
1. Press .
2. Enter the desired gate 1 relay timeout value – (default value is 5 seconds). If the
entered timeout value is out of range an error tone sounds and the input is ignored.
3. Press to lock in the new gate 1 relay timeout value. The unit emits a short, high-pitched
tone to indicate the gate 1 relay timeout value has been accepted. The unit emits a short, high-
pitched tone followed by a low-pitched tone if the gate 1 relay timeout value has been rejected.