Keri Systems EntraGuard Bronze Quick Start - Manual (Page 14)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-001 Rev. J
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 14 of 32
Quick S
tart Guide
Telephone Entry
5.1 Entering Programming Mode
The EntraGuard Bronze unit must be in programming mode to set any of the unit’s operating
parameters. The EntraGuard Bronze unit is pre-programmed with a Programming Code, see the
EntraGuard Bronze Residence Guide (P/N 01911-003) for the code. The factory default is
“999999.”
5.1.1 Entering Programming Mode from the Bronze Unit
1. Press the key three times.
2. Enter the six-digit pre-programmed code.
3. The unit emits a short high-pitched tone to indicate the code was accepted. For security reasons,
the unit does not emit any sounds to indicate if an incorrect code has been entered.
EXAMPLE: Enter the following to enter a Programming Code of “135246.”
5.1.2 Entering Programming Mode from the Residence Telephone
1. Press the key three times.
2. Enter the six-digit pre-programmed code.
3. The unit emits a short high-pitched tone to indicate the code was accepted. For security reasons,
the unit does not emit any sounds to indicate if an incorrect code has been entered.
EXAMPLE: Enter the following to enter a Programming Code of “135246.”
5.2 Exiting Programming Mode
When programming from the EntraGuard Bronze unit, the unit exits programming mode after 1
minute of keypad inactivity. To exit programming mode immediately after entering a programming
command, press .
To exit programming mode when using the residence telephone, press or simply hang up.