Keri Systems EntraGuard Bronze Quick Start - Manual (Page 13)

EntraGuard Bronze
1530 Old Oakland Road, Suite 100 01911-001 Rev. J
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 13 of 32
Telephone Entry
Quick S
tart Guide
5.0 Programming
All operating parameters are programmable from either the EntraGuard Bronze’s front panel
keypad or from any telephone in the residence connected to the same phone line as the EntraGuard
Bronze unit. There are 19 commands available.
• Add Entry Code – allows a user to activate a gate relay from the EntraGuard Bronze unit
• Delete Entry Code – deletes a users entry code
• Delete All Entry Codes – delete all user entry code
• Reset System – resets all programmable values to factory default settings
• Set Programming Mode Code – sets the entry code used to enter program parameters
• Set Ring Mode – sets the ring pattern used when a visitor requests entry
• Set Maximum Rings – sets the maximum number of rings used when a visitor requests entry
• Set Gate 1 Relay Access Code – allows a user to activate the gate 1 relay from the residence
telephone
• Set Gate 1 Relay Timeout – sets the amount of time the gate 1 relay is activated
• Set Gate 2 Relay Access Code – allows a user to activate the gate 2 relay from the residence
telephone
• Set Gate 2 Relay Timeout – sets the amount of time the gate 2 relay is activated
• Set Call Forwarding Telephone Number – sets an alternate telephone number to which entrance
request calls can be forwarded
• Enable Call Forwarding – enables the call forwarding feature
• Disable Call Forwarding – disables the call forwarding feature
• Set Maximum Connection Time – sets the maximum amount of time the telephone line is active
when a visitor requests entry
• Hold Open Gate 1 – immediately holds open the gate 1 relay open for a finite period of time
• Close Gate 1 – immediately closes the gate 1 relay
• Hold Open Gate 2 – immediately holds open the gate 2 relay open for a finite period of time
• Close Gate 2 – immediately closes the gate 2 relay
When entering programming commands, the unit responds to correct entries with a short, high-
pitched tone to indicate the command was accepted. The unit responds to incorrect/invalid entries
with a short, high-pitched tone followed by a low-pitched tone to indicate the command was
rejected.