Cabletron Systems 6E133-25 User Manual
Page 162
Chapter 5: Local Management
5-114
6E122-26, 6E132-25, 6E123-26 and 6E133-25 User’s Guide
link_trap:
Syntax:
link_trap [enable/disable/status] [PORT/all]
Description:
The link_trap command allows link traps to be
enabled or disabled when specifying a single
port, or simultaneously when specifying “all”
or no ports. When one or all ports are specified
to enable, disable, or find their status, their
current condition is displayed.
Options:
Not Applicable
Example:
atm_stp_state:
Syntax:
atm_stp_state [STATE]
Description:
The atm_stp_state command allows the user to
enable, disable, or check the status of the
Spanning Tree Algorithm on all ATM
interfaces. The user must specify the STATE
option as enable, disable, or status. The STATE
field is mandatory.
NOTE
The atm_stp_state command is only available if an
HSIM-A6DP is installed in the module (e.g., 6E13X-25). This
command allows the user to enable, disable, or check the
current status of the Spanning Tree Algorithm on all ATM
interfaces.
-> link_trap status
Port 1 is ENABLED
Port 3 is ENABLED
Port 2 is DISABLED
Port 4 is ENABLED
-> link_trap disable 2
-> link_trap disable all
-> link_trap status 3
LINK TRAP STATUS:
Link traps have been DISABLED on port 2
Link traps have been DISABLED on all ports (1-24)
Link traps are ENABLED on port 3