Cabletron Systems 6E133-25 - Manual (Page 137)

Broadcast Suppression Screen
6E122-26, 6E132-25, 6E123-26 and 6E133-25 User’s Guide 5-89
5.25 BROADCAST SUPPRESSION SCREEN
The Broadcast Suppression screen, Figure 5-31 , allows the user to set a
desired limit of receive broadcast frames per port per second.
Access the Broadcast Suppression screen from the Module Specific
Configuration screen by using the arrow keys to highlight the
BROADCAST SUPPRESSION menu item and pressing ENTER. The
Broadcast Suppression screen displays.
Figure 5-31 Broadcast Suppression Screen
NOTE
The Broadcast Suppression screen may not be available if the
operational mode of the module has been set to SECURE
FAST VLAN or 802.1Q SWITCHING. Refer to your Release
Notes to see what operational modes support Broadcast
Suppression. Refer to
Section 5.15.9 , Setting the Operational
Mode , for instructions on configuring the operational mode of
the module.
Any broadcast frames received above the desired threshold will
be dropped.
Firmware Revision: XX.XX.XX
Broadcast Suppression
1960_56
BOOTPROM Revision: XX.XX.XX
PORT #
1
2
3
4
5
6
7
8
9
10
11
12
Time Since Peak
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
Peak Rate
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
Threshold
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
Module Type: 6E122-26
Slot Number: X
6E122-26 LOCAL MANAGEMENT
Event Message Line
Total RX
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
Reset Peak
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
RETURN
RETURN SAVE [13-24] EXIT