Cabletron Systems 6E133-25 - Manual (Page 100)

Chapter 5: Local Management
5-52 6E122-26, 6E132-25, 6E123-26 and 6E133-25 User’s Guide
5.15.10 Setting the Management Mode
To set the management mode, perform the following steps:
1. Use the arrow keys to highlight the Management Mode field:
2. Use the SPACE bar to toggle the options (DISTRIBUTED or
STAND ALONE) until the desired mode displays.
3. Use the arrow keys to highlight the SAVE command, then press
ENTER. The warning screen shown in
Figure 5-19 displays.
4. Use the arrow keys to highlight the YES command and press ENTER.
The changes are saved and the module reboots.
NOTE
Upon saving the new Management Mode, the module will
reboot.
If the module will be set to STANDALONE, ensure the following
procedures have been completed:
The module has been assigned a unique IP address.
The module has been assigned SNMP community names from
the module SNMP Community Names screen (
Section 5.16 ).
In STAND ALONE management mode, the module does not
use the community names of the 6C105 chassis.