Cabletron Systems 6E133-25 - Manual (Page 108)

Chapter 5: Local Management
5-60 6E122-26, 6E132-25, 6E123-26 and 6E133-25 User’s Guide
5.17 SNMP TRAPS SCREEN
Since the 6E12X-26 and 6E13X-25 are SNMP compliant devices, they
can send messages to multiple Network Management Stations to alert
users of status changes. The SNMP Traps screen is shown in
Figure 5-23 .
Access the SNMP Traps screen from the Module Configuration Menu
screen by using the arrow keys to highlight the SNMP TRAPS field and
pressing ENTER. The SNMP Traps screen displays.
Figure 5-23 SNMP Traps Screen
The following explains each field of the SNMP Traps screen.
Trap Destination (Modifiable)
Indicates the IP address of the workstation to receive trap alarms. Up to
eight different destinations can be defined.
NOTE
It is only necessary to assign SNMP traps if the user desires
the traps to be sent to different addresses than those assigned
in
Section 5.9 , which details how to set SNMP Traps for the
6C105 chassis.
Firmware Revision: XX.XX.XX
SNMP Traps
1960_17
BOOTPROM Revision: XX.XX.XX
Trap Community Name
public
public
public
public
public
public
public
public
Module Type: 6E122-26
Slot Number: X
6E122-26 LOCAL MANAGEMENT
Event Message Line
RETURN SAVE
Trap Destination
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
Enable Traps
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
EXIT