Canon MARKLL WUX10 - Manual (Page 84)

Projector WUX10 MarkII User Commands
- 80 -
Revision History / Date Changes Revised by Approved by
ZSTEPDRV
Zoom lens step drive control
Format
ZSTEPDRV=
WIDE This zooms to the wide-angle end.
TELE This zooms to the telephoto end.
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
"i:OK" is returned when zooming was completed successfully after step drive.
For details on other responses, refer to the "Error List".
Description
(1) This command is used to drive the zoom lens.
(2) This command functions in the same way as when first the "ZOOM" button on the remote
control or main unit panel is pressed and then the "←" or "→" button is pressed.
(3) The amount by which the lens is zoomed is constant, and it is fixed in the system.
(4) If a zooming error occurs, step drive cannot be controlled.
(5) There are no GET commands available for this command.
Example
Control
> ZSTEPDRV=TELE 1-step control is exercised over the zoom toward the TELE end.
< I:OK
* Commands are indicated by ">", and responses are indicated by "<".