Canon MARKLL WUX10 - Manual (Page 73)

Projector WUX10 MarkII User Commands
- 69 -
Revision History / Date Changes Revised by Approved by
SEL
Input signal selection
Format
SEL=
GET□SEL / ?△SEL
AUTO Auto
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X X X X O O X X
Response
"i:OK" is returned if the parameter was set properly.
For '
GET SEL ' or ' ?SEL ', current input signal is returned as
'g:SEL='
(Refer to "Description".)
For details on other responses, refer to the "Error List".
Description
(1) This selects the input signal.
(2) This command functions in the same way as when "Display setting" - "Input signal selection" -
"AUTO" are selected on the menu.
(3) If the input is neither "COMP", "S-VIDEO" nor "VIDEO", 'e:200X INVALID_SOURCE(***)' is
returned as an error response.
(4) If signals are not input, 'e:2010 NO_SIGNAL' is returned.
(5) The current input signal can be acquired using the applicable GET command. ("
GET SEL
")
List of signals which can be detected (1)
Parameter Remarks
PAL Includes PAL-M and PAL-N
SECAM
NTSC Includes NTSC4.43
1080p
1080i Includes 540p (1080i non-interlaced signal)
1035i
List of signals which can be detected (2)
Parameter Remarks
720p
576p
480p
576i Includes 288p (PAL non-interlaced signal)
480i Includes 240p (NTSC non-interlaced signal)
UNKNOWN No-color, 1080p, and other signals