Image – Canon MARKLL WUX10 User Manual
Page 44
Projector WUX10 MarkII User Commands
- 40 -
Revision History / Date
Changes
Revised by
Approved by
IMAGE
Image mode setting
Format
IMAGE=
GET
STANDARD Standard
PRESENTATION Presentation
SRGB sRGB
MOVIE Movie
PHOTO
Environmental light compatible sRGB
DCM_SIM
DICOM monochrome *
* "e:000A INVALID_PARAMETER" is returned if the model is not DICOM compatible
Environment
Power
Input
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
VIDEO
HDMI
None
X O X
-
Response
"i:OK" is returned if the parameter was set properly.
For '
GET IMAGE
' or '
?IMAGE
', current image mode is returned as
'g:IMAGE=
For details on other responses, refer to the "Error List".
Description
(1) This sets the image quality.
(2) This command functions in the same way as when "Image adjustment" - "Image mode setting"
are selected on the menu.
(3) The final settings for the image mode are retained even when the power is turned off.
(4) Changing the setting may modify the following setting values.
Setting
Commands related to the settings
Brightness BRI
Contrast CONT
Sharpness SHARP
Gamma adjustment
GAMMA
Dynamic gamma
DGAMMA
Progressive PROG
Saturation/Hue SAT/
HUE
Memory color adjustment
MEMCADJ
RGB gain/offset adjustment RGBGAIN/RGBOFFSET
Lamp mode
LAMP
6-axis adjustment
6AXADJ
6-axis color correction
6AXR～Y
(5) The current image quality can be acquired using the applicable GET command. ("
GET IMAGE
")