Canon MARKLL WUX10 - Manual (Page 71)

Projector WUX10 MarkII User Commands
- 67 -
Revision History / Date Changes Revised by Approved by
SAT
Color saturation setting
Format
RGBGAIN=▽▽
GET□RGBGAIN / ?△RGBGAIN
Setting values for are -20 to 20.
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X O O O O O X O
Response
"i:OK" is returned if the parameter was set properly.
For
'GET SAT
' or '
?SAT
', current saturation setting value is returned as
' g:SAT= '
For details on other responses, refer to the "Error List".
Description
(1) This sets the screen color saturation.
(2) This command functions in the same way as when "Image adjustment" - "Color adjustment" -
"Color saturation setting" are selected on the menu.
(3) If the input is "HDMI", 'e:200X INVALID_SOURCE(***)' is returned as an error response.
(4) When image mode is not set to "PHOTO", 'e:2020 INVALID_IMAGE_MODE' is returned as an
error response even if the input is "D-RGB", "A-RGB1" or "A-RGB2".
(5) If numerical parameters are outside the range, "e:0801 INVALID_VALUE" is returned.
(6) This sets the currently selected input signal and image mode.
(7) The GET command can be used to retrieve the current color saturation. ("
GET SAT
")
Example
Setting
> SAT=-10 This sets the color saturation to –10.
< i:OK
Reference
> GET SAT or ?SAT This retrieves the color saturation.
< g:SAT=1
* Commands are indicated by ">", and responses are indicated by "<".