Canon MARKLL WUX10 - Manual (Page 62)

Projector WUX10 MarkII User Commands
- 58 -
Revision History / Date Changes Revised by Approved by
PROG
Progressive setting
Format
PROG=
GET□PROG / ?△PROG
0 OFF
1 ON
2 AUTO
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X X X X O O O X
Response
"i:OK" is returned if the parameter was set properly.
For '
GET PROG
' or
'?PROG
', progressive conversion setting is returned as
'g:PROG='
For details on other responses, refer to the "Error List".
Description
(1) This command is used to set the progressive conversion processing to ON or OFF.
(2) This command functions in the same way as when "Display setting" - "Progressive" are
selected on the menu.
(3) This sets the currently selected input signal and image mode.
(4) The current value can be acquired using the applicable GET command. ("
GET PROG ")
* The menu display statuses are as listed in the table below by model.
Menu display statuses, etc.
When signals from a progressive source are input, the progressive conversion setting
cannot be selected, and the field will be blank on the menu.
Example
Setting
> PROG=0
This sets the progressive conversion setting to OFF.
< i:OK
Reference
> GET PROG or ?PROG This acquires the progressive conversion processing status.
< g:PROG=1
* Commands are indicated by ">", and responses are indicated by "<".