Canon MARKLL WUX10 - Manual (Page 35)

Projector WUX10 MarkII User Commands
- 31 -
Revision History / Date Changes Revised by Approved by
FCONTDRV
Focus lens continuous drive control
Format
FCONTDRV=
STOP This stops the focusing.
FAR This initiates focusing toward the far end.
NEAR This initiates focusing toward the near end.
Environment
Power Input
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP VIDEO HDMI None
X O X -
Response
"i:OK" is returned when the drive was completed successfully.
For details on other responses, refer to the "Error List".
Description
(1) This command is used to drive the focus lens.
(2) This command functions in the same way as when first the "FOCUS" button on the remote
control or main unit panel is pressed and then the "↑" or "↓" button is pressed.
(3) Focus drive is started by specifying "NEAR" or "FAR".
To stop the drive, add the "STOP" parameter and send this command.
If no instruction was given to stop the drive, the drive stops at the drive direction end.
(4) The following commands are acknowledged during focus drive, but focus drive will also stop at
the same time.
a. POWER
b. FCONTDRV=STOP
(5) The following commands are acknowledged during focus drive, and a response is returned
while the drive continues.
a. GET MODE e. GET PRODCODE i. LOCAL
b. GET POWER f. GET ROMVER j. RC
c. GET ERR g. GET COMVER k. MAIN
d. GET LAMPCOUNTER h. REMOTE l. [NULL]
(6) For other commands not included in (4) nor (5), "i:BUSY (FOCUS)" is returned, and focus
drive continues.
(7) There are no GET commands available for this command.
Example
Control
> FCONTDRV=NEAR
Control over the focusing to the near end is started.
< i:OK
* Commands are indicated by ">", and responses are indicated by "<".