Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Configuration Manual - Manual (Page 23)

Chapter 2: Programming
TruVision Analog PTZ Camera Configuration Manual 21
You can clear the defined limit stops. Click IRIS+ to enter CLEAR STOPS and
click IRIS+ again to clear the stops.
Elevation set
You can enable the elevation angle of the PTZ camera. You can set ELEVATION SET to ON or OFF.
Presets
A preset is a user-defined monitor position/point. You can simply call the preset number to
change the monitor scene to the defined position. See Figure 7 below.
Figure 7: Preset menu
To set a preset:
1. Go to MAIN MENU > SYSTEM SETTINGS > PRESETS
2. Move the cursor to PRESET NUMBER and click IRIS+ to enter. Click the up and down
buttons to select the preset number to be configured. If the preset has been defined, the
preset label is listed under the number. If it has not been defined,
UNDEFINED is
displayed under the number.
Note: The system-defined presets are displayed on this submenu but they cannot be
changed.
3. Select the preset number.
To edit a preset label:
1. Go to MAIN MENU > SYSTEM SETTINGS > PRESETS
2. Move the cursor to EDIT LABLE and click IRIS+ to enter the edit mode.