Zero point (initial position) setting, Display settings – Interlogix TruVision 960H Premium Resolution Series PTZ Cameras Configuration Manual User Manual

Page 13

Chapter 2: Programming

TruVision Analog PTZ Camera Configuration Manual

4. Click the up/down buttons to increase/decrease the value.

5. Click

IRIS+

button to confirm and exit.

Zero point (initial position) setting

You can define the initial position of the PTZ camera using the

Zero Point Setting

submenu

To change the zero point setting:

1. Go to

Main Menu

System Settings

System Infor Settings

2. Use the direction buttons to move the cursor to

Zero Point Setting

and click

IRIS+

to enter.

3. Click the left/right/up/down buttons to adjust the monitor angle of the PTZ camera

to find the initial position.

4. Click

IRIS+

button to confirm and exit.

Display settings

You can enable or disable the on-screen display for the information of zoom, PTZ
movements, alarms, time, presets, zone, address, error rate, and fan and heat, etc. See
Figure 3 below.

Figure 3:

Display settings menu