Cabletron Systems 6000 User Manual
Cabletron Systems Computer Accessories
Table of contents
Document Outline
- Title Page
- Notice
- Contents
- Introduction
- Network Requirements
- Installation
- Troubleshooting
- Local Management
- 5.1 Overview
- 5.2 Local Management Keyboard Conventions
- 5.3 Management Terminal Setup
- 5.4 Accessing Local Management
- 5.5 The Main Menu Screen
- 5.6 Chassis Menu Screen
- 5.7 Chassis Configuration Screen
- 5.8 SNMP Community Names Screen
- 5.9 SNMP Traps Screen
- 5.10 Chassis Environmental Screen
- 5.11 Port Redirect Function Screen
- 5.12 Module Selection Screen
- 5.13 Module Menu Screen
- 5.14 Module Configuration Menu Screen
- 5.15 General Configuration Screen
- 5.15.1 Setting the IP Address
- 5.15.2 Setting the Subnet Mask
- 5.15.3 Setting the Default Gateway
- 5.15.4 Setting the TFTP Gateway IP Address
- 5.15.5 Setting the Module Date
- 5.15.6 Setting the Module Time
- 5.15.7 Entering a New Screen Refresh Time
- 5.15.8 Setting the Screen Lockout Time
- 5.15.9 Setting the Operational Mode
- 5.15.10 Setting the Management Mode
- 5.15.11 Configuring the COM Port
- 5.15.12 Changing the Com Port Application
- 5.15.13 Clearing NVRAM
- 5.15.14 Enabling/Disabling IP Fragmentation
- 5.16 SNMP Community Names Screen
- 5.17 SNMP Traps Screen
- 5.18 Switch Configuration Screen
- 5.19 Ethernet Full Duplex Configuration Screen
- 5.20 Module Specific Configuration Menu Screen
- 5.21 System Resources Screen
- 5.22 High Speed Interface Configuration Screen (6E12X-26 Only)
- 5.23 Flash Download Screen
- 5.24 Port Redirect Function Screen
- 5.25 Broadcast Suppression Screen
- 5.26 Module Statistics Menu Screen
- 5.27 Switch Statistics Screen
- 5.28 The Interface Statistics Screen
- 5.29 RMON Statistics Screen
- 5.30 Network Tools
- Specifications
- FE-100TX, FE-100FX and FE-100F3 Specifications
- Mode Switch Bank Settings and Optional Installations
- Index