Cabletron Systems 6000 - Manual (Page 112)

Chapter 5: Local Management
5-66 6E128-26, 6E138-25, 6E129-26 and 6E139-25 User’s Guide
2. Use the SPACE bar to toggle to either ENABLED or DISABLED.
3. Use the arrow keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message “SAVED OK” displays.
5.19 ETHERNET FULL DUPLEX CONFIGURATION
SCREEN
The Ethernet Full Duplex Configuration screen, Figure 5-25 , allows the
user to set ports 1 through 24, individually or all at once, to either
Standard Ethernet or Full Duplex operation and monitor each port to see
whether or not it is enabled and linked to another device.
To access the Ethernet Full Duplex Configuration screen from the Module
Specific Configuration Menu screen, use the arrow keys to highlight the
ETHERNET FULL DUPLEX CONFIGURATION menu item in the
Module Specific Configuration Menu screen and press ENTER. The
Ethernet Full Duplex Configuration screen,
Figure 5-25 , displays.
Figure 5-25 Ethernet Full Duplex Configuration Screen
Firmware Revision: XX.XX.XX
Full Duplex Configuration
2311_21
BOOTPROM Revision: XX.XX.XX
PORT #
1
2
3
4
5
6
7
8
9
10
11
12
LINK STATUS
Link
Link
Link
No Link
Link
Link
Link
Link
Link
Link
Link
Link
Module Type: 6E128-26
Slot Number: X
6E128-26 LOCAL MANAGEMENT
Event Message Line
SAVE
OPERATION MODE
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
[STANDARD ENET]
PORT STATUS
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
SET ALL PORTS: [FULL ]
RETURN
RETURN [13-24] EXIT