Cabletron Systems 6000 - Manual (Page 9)

Contents
6E128-26, 6E138-25, 6E129-26 and 6E139-25 User’s Guide vii
5.9 SNMP Traps Screen.................................................................. 5-27
5.9.1
Configuring the Trap Table ........................................... 5-28
5.10 Chassis Environmental Screen ................................................. 5-29
5.11 Port Redirect Function Screen .................................................. 5-30
5.11.1 Displaying the Source and Destination Entries............. 5-32
5.11.2 Changing Source and Destination Ports....................... 5-33
5.12 Module Selection Screen........................................................... 5-34
5.12.1 Selecting a Module ....................................................... 5-35
5.13 Module Menu Screen ................................................................ 5-36
5.14 Module Configuration Menu Screen .......................................... 5-38
5.15 General Configuration Screen ................................................... 5-41
5.15.1 Setting the IP Address .................................................. 5-45
5.15.2 Setting the Subnet Mask............................................... 5-46
5.15.3 Setting the Default Gateway ......................................... 5-47
5.15.4 Setting the TFTP Gateway IP Address ......................... 5-48
5.15.5 Setting the Module Date ............................................... 5-48
5.15.6 Setting the Module Time ............................................... 5-49
5.15.7 Entering a New Screen Refresh Time .......................... 5-50
5.15.8 Setting the Screen Lockout Time.................................. 5-50
5.15.9 Setting the Operational Mode ....................................... 5-51
5.15.10 Setting the Management Mode..................................... 5-52
5.15.11 Configuring the COM Port ............................................ 5-53
5.15.12 Changing the Com Port Application.............................. 5-55
5.15.13 Clearing NVRAM .......................................................... 5-56
5.15.14 Enabling/Disabling IP Fragmentation ........................... 5-57
5.16 SNMP Community Names Screen ............................................ 5-57
5.16.1 Establishing Community Names ................................... 5-59
5.17 SNMP Traps Screen.................................................................. 5-60
5.17.1 Configuring the Trap Table ........................................... 5-61
5.18 Switch Configuration Screen ..................................................... 5-62
5.18.1 Setting the STA............................................................. 5-65
5.18.2 Setting the Age Time .................................................... 5-65
5.18.3 Setting (Enabling or Disabling) the Port Status ............ 5-65
5.19 Ethernet Full Duplex Configuration Screen ............................... 5-66
5.19.1 Setting the Operation Mode .......................................... 5-68
5.20 Module Specific Configuration Menu Screen ............................ 5-69
5.21 System Resources Screen ........................................................ 5-71
5.21.1 Setting the Reset Peak Utilization ................................ 5-73
5.22 High Speed Interface Configuration Screen (6E12X-26 Only) .. 5-74
5.22.1 Configuring an FE-100FX or FE-100F3 ........................ 5-77
5.22.2 Setting the FE-100FX and FE-100F3
Operational Mode ......................................................... 5-77
5.22.3 Configuring an FE-100TX ............................................. 5-78