Cabletron Systems 6000 - Manual (Page 87)

General Configuration Screen
6E128-26, 6E138-25, 6E129-26 and 6E139-25 User’s Guide 5-41
5.15 GENERAL CONFIGURATION SCREEN
The General Configuration screen, Figure 5-18 , allows the user to set the
system date and time, IP address and subnet mask, the default gateway,
the TFTP gateway IP address, the operational mode, the management
mode, set the screen refresh and lockout times, and the COM port
configuration. The General Configuration screen also allows the user to
Clear NVRAM, and enable or disable IP Fragmentation.
To access the General Configuration screen from the Module
Configuration Menu screen, use the arrow keys to highlight the
GENERAL CONFIGURATION menu item and press ENTER. The
General Configuration screen,
Figure 5-18 , displays.
Figure 5-18 General Configuration Screen
The following briefly explains each General Configuration screen field:
MAC Address (Read-Only)
Displays the base physical address of the module.
Firmware Revision: XX.XX.XX
General Configuration
2311_15
BOOTPROM Revision: XX.XX.XX
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr:
Module Date:
Module Time:
Screen Refresh Time:
Screen Lockout Time:
Com: [ENABLED] Application: [LM]
Clear NVRAM [NO]
Module Uptime XX D XX H XX M
Module Type: 6E128-26
Slot Number: X
IP Fragmentation [ENABLED]
Operational Mode: [802.1D SWITCHING] Management Mode: [DISTRIBUTED]
00-00-ID-00-00-00
0.0.0.0
255.255.0.0
NONE DEFINED
0.0.0.0
6E128-26 LOCAL MANAGEMENT
Event Message Line
RETURN SAVE
10/11/97
14:23:00
30 sec.
15 min.
EXIT