Flintec DAD 141.1 - Manual (Page 23)

DAD 141.1 Technical Manual, Rev. 2.2 - February 2014 Page 23 of 54
7.11. Error Codes
Zero key is not enabled (chapter 7.3, menu 1.1)
Out of zero range.
(You are trying to set a zero which is greater than ±2% of the upper display limit)
N/A
Input exceeded ± 3.3mV/V
Load cell connection fail
Requested value out of range
Display overload
– see menu 3.1o
Display underload – see menu 3.1u
The Zero or Tare motion limit has been exceeded. Set Zero or Tare function
disallowed. Review Zero and Tare motion limits set in menu 4.4.