EVCO c-pro giga - Manual (Page 43)

C-PRO GIGA HARDWARE MANUAL
Pag. 43
8.1 Notes on the parameter of the controller relative to the
CAN net configuration
To log on the controller parameters configuration procedure relative to the analogic output act in
the following way :
Both for the remote or built-in user interface :
1.
Ensure that the controller and the user interface are both switched on no utilization isbe
connected with the analogic output
2. Keep pressed at the same time and buttons for two seconds : the first available
voice will be visualized (the voices are relative to the controller; for the voices relative to
the user interface repeat the selection from “reset”).
To select the controller parameters relative to the CAN network configuration:
1. Press and release button to select “Network” voice.
2. Press and release button: if the controller is visualizing the net parameters, the voice
“Input Password” will be visualized: in this case see the following 3. and 4. (in opposite case see
directly point 5.).
3. Press and release button: the cursor blinking.
4. Press and release button to set “ -19”.
5. Press and release button: the first voice available will be visualized; if it is visualizing
the net parameters relative to the controller, the question asked will be which communication port
has to be referred (Local CAN, Wide CAN, UART1 o UART2).
To select a parameter:
1. Press and release button
To modify a parameter:
1. Press and release button: the cursor blinking.
2. Press and release or buttons to select the value
3. Press and release button to confirm the selection done.
4.
Switch – off the controller.
For a quick closing procedure :
1. Press and release repeatedly button
The main parameters of the CAN net are the following :