EVCO c-pro giga - Manual (Page 25)

C-PRO GIGA HARDWARE MANUAL
Pag. 25
Baud rate (max. length = 5 m) 50K
Baud rate (max. length = 2 m) 125K
Baud rate (max. length = 1 m) 500K
Connector Disconnectable screw
terminals
Note:
1) baud rate selectable by two jumpers
2) The CAN connection consists of a cable with twisted pair (both
shielded and not shielded). The first and the last elements of the
system must have the bus terminating resistor connected (impedance
is 120
Ω
). A second twisted pair is used for the feed and the ground
Number 1
type RS485, optoinsulated
Physical layer 2 wires + common wire
Baud rate (max. length 1000 m) 1200 - 19200
Connector Disconnectable screw
terminals
type RS232, optoinsulated
Physical layer Tx, Rx + 2 signals for
modem control + common
wire
Baud rate (max. length 3 m) 1200 - 19200
Connector Disconnectable screw
terminals
RS485 serial
communication
(UART1)
Note:
1) baud rate is selectable by parameters
2) The CAN connection consists of a cable with twisted pair (both
shielded and not shielded). The first and the last elements of the
system must have the bus terminating resistor connected (impedance
is 120
Ω
). A second twisted pair is used for the feed and the ground
Number 1
Backup type Supercup
RTC
(Real Time Clock)
RTC data retention time in the event of a
power failure 3 days
Buzzer Number 1
Signaling LEDs Number 6