Comtrol RocketPort Serial Hub Si Driver Installation for Windows 98 - Manual (Page 4)

Removing an Existing Device and Driver 4
Driver Installation and Configuration
This subsection discusses the following installation and configuration issues:
• Removing an existing device and driver (discussed below)
• Installing the software
• Verifying the installation
• Using port sharing
• Changing configuration parameters
• Adding new RocketPort Serial Hub Si devices to an existing configuration
• “Hot-swapping” devices
See Initial Installation - Quick Reference , if you want to install the product using a quick reference.
Removing an Existing Device and Driver
Use the following procedure to remove any existing RocketPort Serial Hub Si devices and drivers on the
Windows 95/98 operating system. If updating (not reconfiguring) the driver, you may skip Steps 1 through 8
and leave the devices installed, but make sure that you remove the existing driver before installing an
updated driver.
1. Right-click on My Computer, and select Properties.
2. Select the Device Manager tab.
3. Expand the Multi-function adapters node of the device tree.
4. Highlight RocketPort Serial Hub Si 4/8 Port Device.