Comtrol RocketPort Serial Hub Si Driver Installation for Windows 98 - Manual (Page 27)

Installing Modems 27
9. The Modems Properties window displays again. Depending on prior configuration, you may be asked to
enter your country of use, area code, number dialed to get an outside line, and whether you have tone or
pulse dialing.
10. If you need to configure modem properties (maximum baud rate, data bits, parity, and so on), click the
Properties button, make the needed changes, then click OK to return to this window.
Note: For help configuring modem properties, see the Windows Help System.
11. If you need to configure dialing properties (country, area code, calling card number, and so on), click the
Dialing Properties button, make the needed changes, then click OK to return to this window.
12. Click Close to exit the Install New Modem wizard. Your changes take effect immediately. No reboot is
required.