Comtrol RocketPort Serial Hub Si Driver Installation for Windows 98 - Manual (Page 21)

Adding RocketPort Serial Hub Si Units After the Initial Installation 21
16. Click OK to exit to the Windows System Properties window.
17. Click OK to exit to the Windows desktop.
Note: Depending upon the type of configuration changes you made, you may or may not need to reboot your
system. The driver will prompt you to reboot the system, if necessary.
Adding RocketPort Serial Hub Si Units After the Initial Installation
Each RocketPort Serial Hub Si must be installed as a separate Multi-function adapter. Use the following
procedure to add more RocketPort Serial Hub Si units to an existing installation.
1. Connect the new RocketPort Serial Hub Si to the network and power it up.
2. Make sure that the RocketPort Serial Hub Si passes the power-on LED diagnostics.
3. Go to Installing the Device and Driver and repeat the entire procedure.
4. Reboot the system so that the new RocketPort Serial Hub Si initializes.