Comtrol RocketPort Serial Hub Si Driver Installation for Windows 98 - Manual (Page 14)

Verifying the Installation 14
Verifying the Installation
After rebooting the system, the driver downloads to the RocketPort Serial Hub Si. The port LEDs should be
cycling their lights approximately every 30 seconds (instead of the Port 1 LED flashing, which indicates that
the RocketPort Serial Hub Si is waiting for the driver).
Use the following procedure to verify the installation.
1. Open the Device Manager.
2. Expand the Multi-function adapters entry.
3. Select the RocketPort Serial Hub Si.
4. Click the Properties button.
5. Check the Device status.
If the installation was successful, the status message should indicate that the device is working properly.
Note: This message is only meaningful if the hardware LED diagnostics pass. See the Hardware
Installation documentation.
If the status message indicates a problem, check the device as outlined in Troubleshooting . In addition, you
can use the following applications to help diagnose the problem:
• Using Test Terminal
• Using Port Monitor
• Using the Device Advisor