Comtrol DM ATS-NTe - Manual (Page 42)

Certified PCMCIA Adapters 42
Changing the Client Name
3. Highlight the Xircom Wireless Ethernet Adapter Driver from the Devices list.
4. Select the Startup button.
5. Select Automatic for the Start up Type and
select Ok.
6. Select Close to close the Devices folder.
7. Close the Devices control panel, then shut
down the system.
Changing the Client
Name The Client Name is not automatically imported when and if the Computer Name
is changed. Use the following procedure if you need to change the computer name.
1. Open the Network Control Panel and select the Adapters tab.
2. Highlight the Xircom Wireless Ethernet Adapter and the select Properties.
3. Edit the Client Name so that it matches
the Computer Name in the Identification
tab in the Network folder.
4. Optionally, confirm that the following
parameters have the correct preset
values. These are necessary for the
device to operate:
Data Rates Auto
Infrastructure Mode Yes
Interrupt 5
IO Base Address (hex) 300
Power Save Mode CAM
SSID atsnte
Note: SSID parameter must be set to
match the one programmed into
the wireless access point (case-sensitive).
5. Select Ok when parameter values have been confirmed.
6. Select the Close button in the Network folder.
7. Select Yes if prompted to reboot the ATS-NTE.