1) changing output1 output, 2) changing output2 output, 3) changing shading correction mode – Toshiba IK - TU51CU User Manual
Page 37: 4) changing manual shading correction mode, 5) changing rgb sync
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(7) OPTION
/• OUTPUT1 RGB, Y/PR/PB
• OUTPUT2 VBS, Y/C
• SHADING MODE SET, MANUAL, OFF
, • Manual shading setting -128 to 127
^ • RGB SYNC G, ALL ON, ALL OFF
Freeze display ON, OFF
- • Nega/Posi inversion SW NEGA, POSI
Detail signal output ON, OFF
RS232C baud rate 9600bps, 19200bps
(7. 1) Changing OUTPUT1 output
® Set the to OUTPUT1 by pushing [MENU UP], [MENU DOWN] buttons.
(D Select either RGB or Y/PR/PB by pushing [DATA UP], [DATA DOWN] buttons.
(7. 2) Changing OUTPUT2 output
0 Set the ” to OUTPUT2 by pushing [MENU UP], [MENU DOWN] buttons.
(D Select either VBS or Y/C by pushing [DATA UP], [DATA DOWN] buttons.
(7. 3) Changing shading correction mode
0 Set the to SHADING by pushing [MENU UP], [MENU DOWN] buttons.
(D
Select SET, MANUAL or OFF by pushing [DATA UP], [DATA DOWN] buttons.
(7. 4) Changing manual shading correction mode
0 Set the to MANUAL by pushing [MENU UP], [MENU DOWN] buttons.
(D Set manual shading correction by pushing [DATA UP], [DATA DOWN] buttons.
[DATA UP] ------- ►
-^27<--------------- ► 0 <-------------- ► 128
◄---- [DATA DOWN]
* When the shading correction mode is set to anything other than MANUAL, the display turns off, so
the setting cannot be made.
(7. 5) Changing RGB SYNC
0 Set the to RGB SYNC by pushing [MENU UP], [MENU DOWN] buttons.
(D Select G, ALL ON or ALL OFF by pushing [DATA UP], [DATA DOWN] buttons.
* When Y/PR/PB is selected at OUTPUT1, the display RGB SYNC turns off automatically. So RGB
SYNC change cannot be performed.
37