Using the rechargeable battery, Safety precautions, Attaching a charged battery – RCA CC9370 User Manual

Page 14: Removing a battery, Powering the camcorder

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Powering the Camcorder

Using the Rechargeable Battery

The battery must be charged as described on the next page before it can be

used the first time. Initial charging takes approximately 90 minutes. When
fully charged, the battery supplies approximately 75-9.5 minutes of operating
time- depending on how much the monitor, zoom, and pause are used.
Conserve battery power by turning the camcorder off during recording breaks.

Battery Release
Button

Safety Precautions

• Do not short the ;

battery's te.rtriinajs,. i

• Do not attempt to

disassemble or modify

..the battery..No.user-

.. ..serviceable parts are

inside.

■ - V: ' :

• Use the battery only .

. with specified adapter/

chargers and . ■
camcorders. .....

• . Throwing the battery .

. into a fire or exposing

: it to excessive heat -...

over 149 degrees F (65
degrees C) could be

. hazardous.

Attaching a Charged Battery

If the DC cable is attached to the
camcorder, remove it before attaching
the battery.

1. Lift the viewfinder.

2. Slide the battery into the back of

the camcorder. Make sure the
arrow diagram on the battery
points down so the contacts on
the battery and camcorder match.

3. Turn the Power Switch to record

(■ or B). The power indicator
lights.

Removing a Battery

Press and hold the BATTERY
RELEASE button. Slide the battery
up and out to remove.