Battery pack – Kenwood TH-27A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. BATTERY PACK
■ Ni-Cd BATTERY PACK (PB-13)
This battery pack has not been charged at the factory in
order to provide you with the greatest number of
charge/discharge cycles. You must charge the battery
before use. The battery pack will require several
charge/discharge cycles before you can expect to see
the maximum operating period between charges. If the
battery will be stored for greater than 2 months it should
be recharged before use.
■ RECHARGING
Insert the charge plug from the charger (BC-1 4) into the
receptacle on the top of the transceiver. Then plug the
charger into the AC line. Do not allow the battery to
charge for greater than 1 5 hours. The use for life and
battery performance will be reduced if you exceed the
recommended charge period.
NOTE
Recharging should be done within an ambient
temperature between 5°C ~ 40°C (4rp ~ 104°F).
Reharging performed out of this range may not fully
charge the battery.
■ INSTALLING THE BATTERY PACK
Insert the battery pack into the transceiver until it locks
in place.
To remove the battery pack slide the Release button and
pull the pack.
RELEASE button