5-5. mhz scan, 5-7. vfo/memory channel scan – Kenwood TH-27A User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Selecting programmable band scan 1 or 2
When you press the F key, then the 4/PROG-1 key, the
PROG1 indicator lights and programmable band scan 1
is selected.
When you press the F key, then the 5/PROG-2 key, the
PROG2 indicator lights and programmable band scan 2
is selected.
• Programmable Band Scan
1. Adjust the SQL control to the threshold point.
2. Press the SCAN key. The PROG1/PROG2 indicator
will begin flashing as a visual reminder the transceiver
is scanning.
Continue to 4-5-3 step 3.
4-5-5. MHz Scan
1. Adjust the SQL control to the threshold point.
2. Press the MHz key during band scan or programmable
band scan. The MHz indicator will begin flashing as a
visual reminder the transceiver is scanning.
3. Scanning will start in an upwards direction over a 1
MHz range. You can change the direction of scan by
turning the Tuning control.
Continue to 4-5-3 step 4.
4-5-6. Memory Channel Scan
NOTE
Only those memory channels that have data
entered,and that have not been locked out it will be
scanned.
Scan does not start more than 2 channels have data
entered.
Press the F key and then the 6/MEMO key.
The MEMO indicator will light to prepare memory scan.
1. Adjust the SQL control to the threshold point.
2. In the memory channel mode press the SCAN key to
initiate scan.
The MEMO indicator begins flashing as a visual
reminder that the transceiver is scanning.
Continue to 4-5-3 step 4.
4-5-7. VFO/Memory Channel Scan
1. Adjust the SQL control to the threshold point.
2. Press the F key, then the SCAN/VM. SCAN key initiate
VFO/Memory scan.
3. Alternate scanning of the VFO frequency shown on
the display and the memory channel last used.
Continue to 4-5-3 step 4.
25