Kenwood TH-27A - Manual (Page 38)

Calling all mennbers of the group. Calling a specific member.
To call all members of the group, select the memory
channel in which the group code is stored. In this
example, the group code is stored in number 3.
Press the PTT switch.
Communication is possible in both THE PAGING MODE
and THE CODE SETTING MODE.
To call a specific member (for example, member 4), use
the following procedure;
Select the memory in which the remote station code
is stored (in this example, select memory 4.),
or Enter the individual code of the remote station in
memory 0.
Then press the PTT switch.
In the paging mode
In the code setting
mode
From memory 4
Enter the individual
code to 0.
nO^OO
1 LlJ
B APO
■
npu UU
ffi] 1 t 1
B APO
Group code 789 and your station ID code 111 are
transmitted. After the codes are successfully transmitted,
a DTMF tone sounds.
38
Remote station code 444 and local station ID code 1 1 1
are transmitted. After the codes are successfully trans­
mitted, a DTMF tone sounds.