Kenwood TH-27A User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
145.000 MHz band segment by specifying any fre
quency with these two segments. The Tuning controls
would then only tune within these specific bands. The
procedure for specifying the bands is described below.
1. Rotate the Tuning control until the desired lower
tuning range appears on the frequency display.For
example you might want to select the 1 44 MHz band
and dial up 144.100 MHz.
2. Turn off the transceiver POWER switch. Now press
and hold the 8/CAR key while you turn on the POWER
switch.
3. Rotate the Tuning control until the desired upper
tuning range appears in the frequency display.
4. Turn off the transceiver POWER switch. Now press
and hold the 9/TIME key while you turn on the
POWER switch.
5. To confirm that the programming was properly per
formed rotate the Tuning control. The transceiver
should not go above or below the programmed band
limits.
6. To clear both programmed limits simultaneously ini
tialize the VFO memory reset using the procedures
discussed on page 1 9.
You can reprogram either limit independently by follow
ing the appropriate instructions above.
17