Kenwood UD-NF7 - Manual (Page 32)

Connectthe aerial in advance, (p. 7)
Note
Tuning
Manual tuning
1
Press the [O] button to turn on the power.
2
Press the [INPUT] button on the main unit or
[TUNER] button on the remote control
repeatedly to select FM Stereo or FM Mono.
3
Press the [^ n /^ m ] button on the remote
control repeatedly to tune in to the desired
station.
• In case of poor reception of radio wave, auto tuning
may stop.
• Auto scan tuning will skip stations remitting weak
signal.
• To stop the auto tuning, press the button
again.
• When an Radio Data System station is tuned in, the
frequency is displayed first, followed by the name of
the station.
To receive an FM stereo transmission
I —M
1
Press the [TUNER] button repeatedly until
“FMST” appears.
“ST” indicatorflashes. ^^and/or* indicator
flashes when a broadcast is in stereo.
! .............
If the FM reception is weak, press the [TUNER]
button to extinguish the “ST” indicator. The
reception changes to monaural, and the sound
becomes clearer.
Auto tuning
1
Press the [O] button to turn on the power.
2
Press the [INPUT] button on the main unit or
[TUNER] button on the remote control
repeatedly to select FM Stereo or FM Mono.
3
Press the [^^/^M] button on the remote
control for more than 0.5 seconds.
Scanning will start automatically and the tuner will
stop at the first receivable broadcast station.
32