Kenwood UD-NF7 - Manual (Page 12)

Clock Setting (Remote Control
Only)
1
2
3
4
Press the [O] button to turn the power on.
Press the [CLOCK/TIMER] button.
Within 5 seconds, press the [ENTER] button.
To adjust the day, press the button
and then press the [ENTER] button.
Press the [^N/^w] button to seiect 24-hour
or 12-hour dispiay and then press the
[ENTER] button.
■> “0:00”
The 24-hour display will appear.
1
(0:00 - 23:59)
“AM 12:00”
The 12-hour display will appear.
i
(AM 12:00 - PM 11:59)
“AM 00:00”
The 12-hour display will appear.
____ 1 (AM 0:00 -PM11:59)
6
Toadjustthehour,pressthe[^^/^N]
button and then press the [ENTER] button.
• Press the button once to advance
the time by 1 hour. The time wiii be changed by
pressing the button repeatediy.
7
Toadjusttheminute,pressthe[^N/^H]
button and then press the [ENTER] button.
• Press the button once to advance
the time by 1 minute. Hoid it down to advance
the time by 5 minutes intervai.
To readjustthe clock
1
Perform step 1 at “Setting the ciock (Remote
controi oniy)”.
step 5 (seiecting 24-hour or 12-hour dispiay) wiii
be skipped.
To change the 24-hour or 12-hour
display
1
Ciear aii the programmed contents.
Referto the “Factory reset, ciearing aii memory”
in p. 44.
2
Perform step 1 at “Ciock Setting (Remote
Controi Oniy)”.
Display Brightness Control
To dim the dispiay brightness, press the [DiMMER/
NETWORK STANDBY] button on the remote controi.
FDimmer 1 (Display is dim).
' V
Dimmer 2 (Display gets dimmer).
Dimmer Off (Display is bright).
To confirm the time display
1
Press the [CLOCK/TiMER] button.
The time is displayed for 5 seconds.
Note
When power supply is restored after unit is plugged in
again or after a powerfailure, time indicatorwill flash.
Reset the clock again.
12
5