Kenwood TM-441A User Manual
Page 55
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DTMF unit DTU-2
1. Remove the 2 screws securing the Top cover.
2. Carefully remove the top cover. (Fig.l )
3.
Remove the backing from the small cushion
provided with the DTU-2 and attach it to the back of
the DTU-2 as shown in Fig. 2
4.
Plug the three connectors into the sockets in the
units.
DTU-2
5. Attach the cable from DTU-2 as shown in Fig. 2 and 3.
6. Replace the cover and tighten the screws to complete
the installation.
OInstalling TSU-6 and DTU-2
Attach these units on the top of VCO shield (Fig.3).
55