beautypg.com

Kenwood TM-441A User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

5-1-4 Microphone

(D ®

@

p@ 0® 00

@ ®

U.S.A.

European version

version

dXDUP/DOWN switches

These switches can be used to increase or decrease
the VFO frequency, the Memory channel number,

and the Tone frequency, etc..

(D PTT (Push to Talk) switch

The transceiver will transmit whenever this switch is
depressed. Scan operations may be canceled by press­

ing this switch without transmitting.

@CALL key (except European version)

This key functions just like the CALL key on the front
of the radio.

1750 key (European version)

The transceiver will transmit with 1750 Hz repeater
access tone whenever this switch is depressed.

(DVFO key

This key functions just like the VFO key on the front

of the radio.

(D MR key

This key functions just like the MR key on the front of
the radio.

(Z) PF (Programmable Function) key

This key can be programmed to perform any of the
following functions:

MHz key (Initial setting from the factory); or SHIFT-
key; or TONE key; or REV key;or DR/DT key ; or LOW
key.

To program the key use the following procedure:

1. Turn the POWER switch on the transceiver OFF.

2. Press and hold the key on the front panel of the

set that corresponds with the function you wish to
program the microphone key to perform.

3. Turn on the POWER switch while the key on the

front panel is held in.

4. Release the front panel key.
One additional function can be programmed that is
not included on the front panel of the transceiver.
This is known as the MONITOR function. This will al­
low you to open squelch to check the band for a clear
frequency. This will function even if you are operat­
ing in the CTCSS decode mode or DTSS mode or PAG­

ING mode.
MONITOR programming
Press and hold the F key on the front panel as you

turn on the POWER switch of the transceiver and
then release the F key.

(D 16-Tone DTMF keypad (U.S.A. and CANADA version

only)
These buttons are used to activate the DTMF encod­
er.

(D LOCK key

This key will deactivate all functions of the micro­

phone except the PTT function and DTMF key pad.

15

This manual is related to the following products: