Kenwood TM-441A - Manual (Page 17)

5-2-2 Frequency Selection
You can change the dial frequency while in the VFO
mode. The frequency can then also be stored in
memory, or in the call channel using the techniques
that will be described in this manual.
MR key
# VFO Mode Operation Frequency Selection
1. Press the VFO/M^V key to select the VFO mode.
2. Rotate the tuning control or press the microphone
UP/DWN switches to select the desired frequency.
# Memory Channel Selection
1. Press the MR/M key.
2. Rotate the tuning control or press the microphone
UP/DWN switches to select the desired memory
channel.
# CALL Channel Selection
Press the CALL key to select the Call channel.
5-2-3 Frequency Step Selection
The frequency step is indicated in the chart below.
STFP
5i =^15^ ± 20
t n2.5? :^25
TM-241A/E
o o o o o o
TM-441A/E
o o o o o o
TM-541A/E X
o
X
o o o
To select the desired tuning or scan step size use the
following procedure:
1. Press the VFO/M^V key to select the VFO mode.
2. Press the F key momentarily. The F indicator should
light in the display.
3. Press the REV/STEP key within 10 seconds of pressing
the F key. The current frequency step size will be
displayed.
17