Kenwood TM-441A - Manual (Page 27)

1. Adjust the SQL control to the threshold point.
2. Press and hold the MR/M key for longer than 1 sec­
ond. The MHz indicator will flash as a visual reminder
the transceiver is scanning.
5-5-5 Memory Channel Scan
3. Scan will begin at the current memory channel and
proceed sequentially .i.e.Ml ^ M2 -> M3 etc. Only
those memory channels with data entered are
scanned.
4. Scan will stop whenever a signal is received ( t h a t ac­
tivates the BUSY indicator) for a limited time.
5. Press the PTT switch or any front panel key to stop
scanning.
5-5-6 Memory Channel Lockout
The Memory Channel Lockout function allows you to
temporarily skip unwanted Memory Channels during
Memory Channel scan.
1. Press the M R / M key to select the Memory Channel
mode.
2. Select the Memory Channel that you wish to skip by
using the Tuning control or the microphone UP/DWN
switches.
3. Press the F key for longer than 1 second. The F indica­
tor will flash. Within 10 seconds of pressing the F key
press the MR/M key. A star (★) will appear to the left
of the Memory Channel number . This indicates the
Memory Channel will be skipped during the Memory
Channel scan operation.,
1 second.
4. Repeat steps 2 and 3 to lock out any other Memory
Channel that you want to skip
5. To cancel the lockout , select the desired Memory
Channels as described in step 1,2,and 3 above.
The star (★) will go out. The Memory Channel will
now be scanned normally.
27