Kenwood TM-441A - Manual (Page 42)

5-10-1 Paging Code Memories
There are five(5) paging code memories.
Use
PA Store your individual ID code in memory.
PO
Automatically stores the calling station’s
code during reception. Can temporarily
set code for the station.
P1-P3
Stores group codes and local station
codes in memory.
5-10-2 Setting the Paging Codes
1. Press the DR/DT key to enter the paging mode. The P
indicator will light.
2. Press the F key, then press the DR/DT key while the F
indicator is on. The code setting mode will be
entered and the memory channel indicator will flash.
4. Press the DR/DT key. The first digit will flash.
(Not necessary this operation if you use DTMF
microphone)
5. Set the desired number with the tuning control and
press the DR/DT key (or key 0 to 9 on the microphone
with DTMF). The first digit will be set, and the
second digit will flash.
3. Set the desired memory (0 to 3 or A) with the tuning
control (or key 0 to 3 or A on the microphone [op­
tion] with DTMF).
6. Set the second and third digits with the tuning
control, and press the DR/DT key.
7. If, after 10 seconds, no key has been pressed, or a key
other than DR/DT or MR/M is pressed, the code will
be set.
42