Kenwood KA-V9500 - Manual (Page 9)

CENTER SPEAKERS switch
Up to two center speakers can be connected to this unit.
Set the CENTER SPEAKERS switch according to the number of the center speakers.
0 When one center speaker is connected: {the output
power is doubled compared to two-speaker operation)
Connect the speaker to the SINGLE (BTL) terminals.
0 When two center speakers are connected:
Center speaker 2 Center speaker 1
-o-W-o-
5) (o' Center speaker
► Sound will not be output correctly if the switch is in the DUAL
(1 and 2) position.
► The center balance adjustment is not possible.
► Sound will not be output correctly if the switch is in the
SINGLE (BTL) position.
INPUT LEVEL control
If the reproduced sound is distorted,
adjust this control to suppress
distortion. For normal operation,
set to the center position.
Connection of PRE OUT jacks
Sound will not be output from the speakers if they are connected directly to the PRE OUT jacks. The output from these jacks should
be connected to speakers with built-in amplifier or to exclusive amplifiers to which the speakers are connected.
0 Connection to CENTER, FRONT and REAR jacks
speaker
© Connection to SUB WOOFER jack
Speaker with built-in AMP
r Woofer I
» When the CENTER jacks are connected, be sure to set the CENTER
SPEAKERS switch to DUAL (1 and 2) position.
> Use these jacks if you want to listen to the speakers with larger volumes
or with different tones.
If you want to listen to richer bass sound, connect
the exclusive amplifier for the woofer to this jack,
and connect the woofer speaker to the amplifier.
KA-V9500 (En) 9