Surround information memory, How to save surround setup in memory, From the remote control unit only) – Kenwood KA-V9500 User Manual

Page 38: Press the m/l (memory input) key, 2 save the current setup in memory, Note, How to recall a surround setup, I press the m/0 (memory output) key, 2 recall a memory

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Surround Information Memory

Surround information memory and Surround title lists functions

For the enjoyment in Surround modes, it is required to set the levels of the channels, delay time, etc., as described on pages 32, 33, 34,

36 and 37. The Surround information memory function makes it possible to store such information in memory.

Example: To enjoy movie in Dolby Pro Logic Surround, Normal mode

0 Front and Center parametric equalizer curves

0 Surround mode selection Dolby Pro Logic

0 Center mode selection -► NORMAL position

0 Channel level adjustments using test tone

0 Delay time setting

The Surround Information is set by the steps above. The Surround Information Memory function allows to store up to five sets of Surround

information set in this way in memory. In addition, a name can be assigned to each set of information by means of the Surround Title List

function.

■ How to save Surround setup in

memory

(from the remote control unit only)

Press the M/l (Memory Input) key.

SUFWOUND MEMO

Select

Surround

Memo

Nurrber

to save.

■A’ 'B'

•D‘ 'E’

2 Save the current setup in memory.

dj m dj cn cn

► Press desired one of the to [1] keys.
» The current parametric equalizer curves. Surround mode,

delay time, center level, center balance, rear level and rear

balance, etc.

Note:

If the parametric equalizer is OFF while the source direct function

is activated or the Surround mode is Bypass, the display as shown

below appears and the Surround information cannot be stored in

memory.

■ How to recall a Surround setup

(from the remote control unit only)

I Press the M/0 (Memory Output) key.

SUmOUND MEMO

I M/l [ I MZO

Please

select

surround memory.

A *

TOP GUN *

B *

♦

C *

it-

D *

it-

E *

2 Recall a memory.

dJ dJ EEJ EO OD

• Press desired one of the to [1] keys.

• Example: Display when the 0 key is pressed

» TCP GUN t

OaAY TI^E 15.0«

-lOdB

Note:

The title name is displayed when it has been input with the Title

Edit function. Please also refer to "Title Edit function".

KA-V9500 (En)