Kenwood KA-V9500 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

I How to program the remote control functions of other components

under the ^'learning" keys of this remote control unit

1 Set the LEARIM/USE switch to LEARIM.

Press the learning key of RC-V9500L under

which you want to program the function
signal.

ifDTfffaOfw' 0

lD'iQ|[ikK)€,0.: Q;Q^^G0CSi 1 :

Qi|'B dgSiCi’s'rajflo-o-at

• LEARN indicator will light up,

I Set the A/B/C select switch to the desired
* position.

[

Within 30 seconds after pressing the key

^ above, press and hold the key of the other

remote control unit which contains the func
tion to be programmed (stored).

Press and hold

ulaDWflmo 0 1 □¡'□T

BEiimioii 0

JB № Qw

:8'Si a

• The LEARN indicator changes from steady lighting to blinking,

indicating that the function signal is being programmed.

[ Place the remote control unit of another com-

ponent with this remote control unit (RC-

V9500L) so that their heads (signal transmit
ters) face each other.

j When the LEARIM indicator goes off after

blinking twice, release your finger from the
key of the other remote control unit

Signal is programmed under this key.

> Be sure to hold the key of the other remote control unit

depressed until the LEARN indicator goes out.

» The programming is completed when the LEARN indicator

goes out after two times of blinking.

I To program another function signal under another key, repeat

steps 4 to 6 above.

KA-V9500 (En)