Kenwood KA-V9500 - Manual (Page 30)

DOLBY PRO LOGIC, 3 STEREO adjustments (Remote control unit)
■ Adjustments in NORMAL or WIDE mode (in dolby pro logic or 3 stereo mode)
Preparation: Set the parametric equalizer to OFF.
Enter the DOLBY PRO LOGIC or 3 STEREO
* mode.
» The DOLBY PRO LOGIC mode and 3 STEREO mode are
alternated every time the key is pressed.
[ Select the NORMAL or WIDE mode.
• Every time the CENTER MODE key
is pressed, the center modes of the
DOLBY PRO LOGIC mode are
svAiitched in the following order;
NORMAL ^ WIDE PHANTOM
t________________ I
The center modes of the 3 STE­
REO mode are switched alternate­
ly as follows:
NORMAL WIDE
[ Turn the test tone ON.
TEST TONE
> Press from your listening position.
4 Press the TEST TONE MODE key.
TEST TONE
I Every time the key is pressed, noise-like test tone is output
from different speakers in order of Left Center -► Right
-►Rear (Rear speakers are not used in 3 STEREO mode).
Holding the key depressed switches the tejst tone m.odes
every 2 seconds.
[ Adjust the balance between all speakers so
' that their volumes are the same.
Large
LEVEL/BALANCE A k I
j REA f T) /w(i™OLLER^\ !
'------------1 I---------------- > Volume
^ K Small
Left -----------Balance-------- »-Right
• When two center speakers are used, adjust the left and right
balance of them.
• The REAR BALANCE controls are adjusted to make the
volume levels from the right and left rear speakers equal.
• The rear speakers are not used in the 3 STEREO mode. In
this case, therefore, adjust so that the volumes from the
three front speakers are equal.
0 Terminate the adjustment.
• Press the TEST TONE ON/OFF key to OFF.
TV screen during adjustment:
In DOLBY PRO LOGIC, NORMAL or WIDE mode:
DOLBY PRO LOGIC NORMAL
C R
■ ■ ■ ■
1 1 1 ! nil
-lOdB -lOdB
TEST
-lOdB -lOdB
S
■ (REAR) ■
—speaker from
which sound
is output
In Dolby 3 Stereo, Normal or Wide mode:
DOLBY 3 STEREO NORMAL
L C R
-lOdB -lOdB
TEST
“Speaker from
which sound
is output
3D KA-V9SOO (En)