How to play a video source, 2 select the video source to be viewed, 3 start playing the selected video component – Kenwood KA-V9500 User Manual
Page 22: 4 adjust the volume, Audio injection operation, Playing back a video source
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Playing back a video source
[ How to play a video source
1
Switch ON the power of the monitor TV
connected to the MONITOR OUT jacks.
2
Select the video source to be viewed.
r VIDEOS if VIDE
02
I I VIDEOt I
j
AVAUX I I DBS^
1
I VDP
\
3
Start playing the selected video component.
• The picture is reproduced on the monitor TV screen, and
the sound is reproduced through the speakers.
4 Adjust the volume.
VOLUME CONTROL
* The audio operation procedure is the same !
scribed in "Playing back an audio source".
; that de-
_______ /
Note:
The characters "VIDEO 1" in the display window will blink if the
VIDEO 1 is selected with the input selector key when the VIDEO
1 REG switch is set to either VIDEO 2 or VIDEO 3. In this case,
set the VIDEO 1 REG switch to SOURCE.
O o'
1
1 a
w
s-s-
f
OffiE»!
AUDIO INJECTIO^J key
■ Audio Injection operation
This feature allows to replace the audio of the video
source being played back with the audio of another
source.
© Play a video source.
© Press the AUDIO INJECTION key.
AUDIO INJECTION
© Select the source to replace the audio.
To cancel audio injection
Press the AUDIO INJECTION key again.
AUDIO INJECTION
TV screen when the TUNER audio is selected for
Audio Injection
> The Audio Injection function is also canceled when the POWER
is switched OFF.
22
KA-V9500 (En)