Kenwood KA-V9500 - Manual (Page 16)

Remote control operation
■ To check the programmed
(stored) contents
1 Set the LEARN/USE switch to USE.
LEARN« >USE
_OQ
\ Press the key you want to check the function
■ of.
> Check to see if the intended function is
^ activated.
I To change the programmed
(stored) contents
Re-start the programming (storing) operation.
I The previously-programmed contents are cleared automatically
and replaced by the newly-programmed contents.
■ To perform normal remote con­
trol operation
J Set the LEARN/USE switch to USE.
LEARN. «USE
Press the "learning" key under which the
required function signal has been pro­
grammed.
• The TRANSMIT indicator blinks and the remote control
function is performed.
■ To clear the whole of the pro­
grammed (saved) contents
<-----------------------------------------------------------------------V
1 Set the LEARN/USE switch to LEARN.
LEARN« «USE
2 Set the A/B/C switch to "C".
□ml
3 Press any key.
• The LEARN indicator lights up.
I Remove the battery case cover on the rear of
^ the remote control unit.
[ Press the Reset key inside the battery case
' with a ball-point pen tip, etc.
Reset Key
> All of the previously-programmed contents are cleared simulta­
neously and the remote control unit is reset to the initial
condition.
Almost all of the remote control systems used with other AV components use the same infrared system as this unit. This means that this
unit is capable of programming the functions of almost all remote-controllable components, Before programming, please read carefully the
instruction manuals of other AV components as well as this Instruction Manual.
Notes:
1. If the optical output power of the other remote control unit is too large, programming could fail. In such a case, place the remote control
unit at a greater distance from this remote control unit.
2. If both the LEARN indicator and TRANSMIT indicator blink simultaneously, either the key is not a "learning" key which can be used for
programming or the current programming is incomplete. In such cases, program the function again under a "learning" key.
3. Programming is also impossible if the other remote control unit uses a signal format other than the infrared system, if it uses a special signal
modulation format, or if the storage capacity of this unit has become full.
4. 30 seconds after a "learning" key is pressed, the LEARN indicator goes from on to off (extinguished). As programmming is impossible while
the indicator is off, press the "learning" key again to light the indicator.
5. If more than one "learning" key is pressed, the function signal is programmed under the last pressed key.
6. Never attempt to program (store) the remote control functions of appliances other than AV components, such as air condition­
ers.
16 KA-V9500 (En)