Windbreak, To cancel windbreak, Setting the confirmation sounds – Sharp VIEWCAM VL-WD650U User Manual
Page 71
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Windbreak
The windbreak function allows you to reduce
annoying noise from strong winds when
recording.
1
Set the camcorder to TAPE-CAMERA
mode.
2
Press the MENU/DISPLAY button until
the menu screen appears.
3
Select #, then press ►► on the Opera
tion button. Select “WIND” (®), then
press ►► (®).
4
Press ■ or ►/ II to select “ON”, then
press
W I N D
I
on
5
Press the MENU/DISPLAY button to
turn off the menu screen.
To cancel Windbreak
Select “OFF” in step 4 above.
Note:
• Keep the windbreak function off during normal
recording. If it is left on, the recorded audio may
sound somewhat muffled when played back.
Setting the Confirmation
Sounds
A confirmation sound is made when you turn
on or off the Power switch, press the REC
START/STOP button, or perform other desig
nated operations. Use the procedure below to
change the type of sound or to turn off the
confirmation sounds altogether.
Type of Confirmation Sound
Settings
CHIME:
A chiming sound is made.
BEEP:
An electronic beeping sound is made.
OFF:
No confirmation sound is made.
1
Press the MENU/DISPLAY button until
the menu screen appears.
2
Select ETC, then press ►► on the
Operation button. Select “SOUND” (®),
then press ►► (®).
SOUND
t'l TIME CODE
BEEP
TC OUT
DEMO MODE
\NGUAGE
OFF
3
Press ■ or ►/ II to select the desired
sound setting, then press
S O U N D
I B E E P
g
<
s
O
s.
Tl
g
4
Press the MENU/DISPLAY button to
turn off the menu screen.
Note:
• If “OFF” is selected, the sound effect of a
camera shutter closing in PHOTO SHOT mode
and CARD-CAMERA mode will also be turned
off.
56